I think we would all agree that affordable rear 2g awd axles would be nice to see. Dsm grave yard has rears for 275 but no one wants to deal with them.
First of all I must say I strongly suggest you dont do this considering the major power loss you will suffer. But if you must do it your going to need to use the ecu and harness out of your vw no question. You will also need to rig up your diesel fuel pump into the dsm tank. If your friend is a...
Seems like a good buy. Look at it like this, a running 4g63t engine 600 all day. Trans and t case, prob 3 or 400. 16g if its mhi 250 to 300. You got your money back right there and the rest is profit.
So as for the crank I redid everything just how we talked about and it went great. I also got my new front case in from jnz. Only problem I had was I had to switch the castle plug over from my old case to the new case. Since I didnt have a o ring for it I had to get one out of my o ring kit and...
Thank you so much gst with psi, I will remove the crank and re check everything tomorrow. Once I reinstall everything should I torque them to 49 or 66 since they have already been torqued that tight?
And gst with psi, my readings are wrote down at work ill post them tomorrow, they were in spec though.Any ideas on what I should do about my torque issue? Should I loosen the mains and re torque them to spec?And sorry my question was can I reuse the main bolts?This was my torque...
Well today I got the crank bolted in, I did plastic gauge first then I cleaned and lubed everything and torqued my mains down to 18ft lbs and a quarter turn. I used my old mains is that a big deal? And I used the same sequence as we do for our head studs.
Ok guys I just got a rebuild kit, I went with an evergreen. Would any of you use this head gasket? Im going to use the other gaskets and king bearings but idk if I should use this head gasket.