Ouch, that's what I get for not getting on here anymore. There is only one grease fitting. I just pumped it until it started coming out the boot. The heim joint doesn't have any way to fill it with grease, you don't want to do that anyways. Just to note, no issues with these parts despite a...
I just had the rear aligned again recently. Mine is at -1.3 degrees. You should have some negative camber in the rear. Alignment is cheaper than tires...
I've looked up lots of info on a few different DSM forums on the Mustang wheels subject, but they were in reference to the 17x9s. These look like a nice set of track beaters and was think about getting them. Big question is can I run them without a spacer?5 lug 17X 8 black wheels
I knew I'd be seeing more of the Wenatchee Valley crew:rocks: We were thinking about renting this house in E. Wenatchee with a massive 30x30 1 car garage;) But know we looking into buying a house out in Quincy. Also has a big 3 car garage just not as cool as the other one. I was just...
I recently accepted a promotion in Quincy and we will be relocating over there. We have not decided on whether or not we want to live in Quincy or move back to Wenatchee where I'm from. Anybody live out on the Plateau?
When my rear pads go out I am going to replace the whole thing with a 3kgt setup. I need to justify it somehow to the old lady:shhh: The problems that I see are 4 bolts rears are required, an issue for earlier 1Gs. Also the e-brake cable will need to be swapped/spliced/adapted. The other...
Ok here are the picts. Sorry for the poor quality it's dark and my camera is old.For removal. I think it was either a 17mm or 19mm for the all the nuts and bolts. Knocked the outside loose with a impact wrench separated it with a pickle fork. The inside nut/bolt is an...
I have these on my car. They do the same job and they replace the inner bushing with a heim joint. 3kgt and 1G suspension is nearly identical. They're a good vendor and more affordable than that eBay link.Control Arms 3SX TT Camber - Mitsubishi 3000GT / Dodge Stealth
Ok here is what I have found out so far. My idea is to use a EVO knuckle, since all macpherson strut Mitsu use the same basic design the real issue is attaching the knuckle to the car. There are four points that the knuckle attach excluding brake lines and ABS sensors, so here is what I was...