well i finally installed the BC 272s and the car idles pretty smoothly after a little tuning and runs sweeet. i definitely have some traction issues to sort out now...lol. thanks for the input guys

i also recommend the aem uego wideband over the cams and WI. since you have dsmlink, the wideband will assit in tuning and getting a few horses out of the car as is. then get either the WI kit or cams. thats what i did, but havent installed the cams yet, next on the list is definitely WI...

like this?

Hi,i just got a rear wheel hub to finally replace the bad bearings. however my car has abs and im not sure i got the rt thing.is there anyway to look at a rear wheel hub assembly and tell that it was for a 2g with abs or without abs?thanks

mike i guess its safe to say that u can remove cams from your parts wish them huh.

anyone else running them ?anyone installed these 272s and done any dyno test with them ?

hey mike, sounds good. so your saying that u feel a significant difference between the stockers and the bc? since u have dsmlink, wouldnt raising the idle a little help with the lumpiness? i bought the bc 272s have got them yet tho.

the lift appears to be a little lower than the hks 264s and 272s. but for the price, bc cams seem to be something to consider.bc 272s, 10.18 in. and 9.66 ex. & on the hks site, it shows both 264 and 272s cams at 10.3 in. and 9.8 ex. so it appears like the bc are somewhat of an under dog in...

Does anyone know where we can get a sway bar that runs along the floor behind the front seats and bolts the the seat belt mounts?heres is a pic of genaral idea,but this one req. drilling, which i want to avoid. im almost sure in the past that i've seen a similiar bar that can be...

the one i saw on ebay is the same as the one in the pic i provided, which requires drilling, which i want to avoid. i want to know if and where one is made to run along the floor but bolt up like the DGI bar (see 3 pics down, part # 10450) http://www.dgiautomotive.com/thanx

Does anyone know where we can get a sway bar that runs along the floor behind the front seats and bolts the the seat belt mounts?heres is a pic of genaral idea,but this one req. drilling, which i want to avoid. im almost sure in the past that i've seen a similiar bar that can be...

Hi,i'm installing my aem wb gauge set up tomm. in my 2g. and have a couple of questions.I've been reading a few treads stating that many of us are powering the aem wb on the 2g from pin 12 but i am also read a tread stating that aem strongly recommends that we hook the power and ground...

Hi,Has anyone heard of these coilovers? My friend bought them at a car show and was told they're for the 2g eclipse. These are blue and as far as i know D2s are purple but is it possible that D2 manufactors these. As shown it says Driver Art Racing Sport on the banner, with the D2 picture...

ok, i called RRE and they said that the bar is made to order and takes approx. 2 wks. its supp. cost a little over $100. for the 2g they prepare just the triangular bar that needs to be welded to your 2 pt. strut tower bar to make 1 piece that now also bolts to the firewall. its supposed to...

im planning on upgrading the car's handling soon. this bar looks good, however, is it better than the 2 point strut tower bar because it also bolts to the firewall? is it worth replacing the 2 point strut tower bar i now have with this one?thanks