I basically took everything off of my 90 trans and swapped it to the 2g, brackets and all. I didn’t modify the shift arms or swap shifters or anything, I tried to adjust the cables and no luck. It feels like there’s nothing there in second gear at all, but all other gears work perfect, I think...
I have a 1990 talon tsi. I had swapped a 2g trans into it and first gear seems to be fine but 2nd is hard to find and pops out. I swapped everything except the shift cables, they’re still from 1990. Could this be the cause of my issue with 2nd gear or is there no difference between the cable...
Make offer. 115xxx miles. 1990 awd dsm has some rocker rust. 2nd gear pops out sometimes.
Starts and runs, but stalls when stopping. It could be the coolant temp sensor or because it needs to be tuned, I’m not sure haven looked too much into it. The car has been sitting for a few months. It has...
Ecu sensor ground was burnt up. I’m assuming the cause was the cas. It was an aftermarket part form cardone, it was causing the mpi relay to turn the fp on and off randomly, while ignition was on run not started. Changed cas, now mpi relay issue went away. I’m gonna check some other wire issues...
So I found out last night that the mpi relay was acting all hectic because I had a non oem cas on it. So every time I’d turn the key after the first initial prime, it would click on and off. I put the original working cas on it and the mpi relay issue stopped. But the car still doesn’t run for...
I have 2 other ecu’s but they’re basically destroyed and they don’t start the car, The caps are fried. Will a fwd ecu at least start an awd or is there a difference? I know someone with a 90 laser.
I’ll check on it later when I get off work. But also I forgot to mention this in the last post. after it starts and dies, if I go to restart it the fp primes on and off inconsistently, mpi relay clicks when fp turns on and off, and my tach jumps around while the fp is priming on and off. I also...
1990 talon tsi. Had just got the ecu fixed by ecmtuning. Car ran great for a good couple months, now I’m having a no start issue. I had just done a 2g trans swap, after that is when It started happening. I start the car it runs for 2 seconds then shuts off. I tested the cas by spinning the wheel...
I’ll post a log today or tomorrow. I’ve been really busy with work and stuff but I’ll get it by the end of the weekend. My coasting fc is also really high at like 1000 could that be part of the issue?
Fuel pressure is at 37psi while idling. The clutch is new and fully bled. I adjusted the rod for the clutch master. This issue is new right after I did the clutch rpms would drop but always come back up. I had a wiring issue with the ptu that had the car down for a while. But after I fixed it...
i get my car running finally and go for a drive. At The first stop sign she dies. So I start it back up, starts rich so I took it back to the garage and opened up link. Set base timing, set the biss screw, and set the tps. Take it for a drive again she’s fine, then I come to a stop, it try’s to...
I’ve checked all that stuff several times to see if I missed anything. So after checking every possible thing, I got pissed and started looking for issues w the PTU wiring.Connector looks good and everything, so I decided to checking for continuity. I start on pin 54, the spark output on the...