I am having the same issues. Freezes whenever I try to log. Only thing I can do is display and clear DTC's. I have put in a ticket on evoscans website, but havent recieved much help.
Ok guys I burped the system today. I turned the heater on and topped off the coolant and started the car and let it run with the cap off. The bubbles started coming and slowly started to disappear. It got to the point where the bubbles coming out where barely recognizable but thats the best it...
I did a few weeks back. I was told to test it at the pressure that my cap was rated at. So I tested it to 13 psi and it held fine. Also as stated above, it passed the leak down test and compression test. I'm replacing the thermostat with a new 170 degrees, but was thinking that maybe I need to...
It is actually my car that he is talking about. I didn't know how to post videos so he made this thread for me. When the car is cold, I still see air bubbles floating up. It's not shooting out like in the video, but they are still there.
Well I have been on the hunt for a 2g for a while now. After traveling out of state a couple of times and coming home empty handed, I finally found one locally. It literally met all of my requirements and then some. Well here are some pictures. Sorry for the camera phone pics. I'm going to...
I wish I could wait it out and see if anything gets better, but I havent bought the car yet due to this issue and he cant really wait on me too much longer, as he needs the money and has another potential buyer. I really want this car as it has a good beginning platform (Jacks Transmission, ACT...
I used two different compression tester. Both different brands. And both would not go over 90 psi. I did a compression test with a cap full of oil in each cylinder and the compression jumped up to 160.
Since the idle is a little rough, I will check the timing tomorrow mourning. Would being a tooth off time cause a low compression reading across the board?