Thanks for the input, I tried re-installing the stock maf and now it will idle. Weird that on SD it would barely hit then die. Now I just need to get the fuel close so I can figure the SD issue. The first log is running on stock Inj. values, second log is running on ECM Link's suggested values...
So the car is still not idling, I reset the InjBatteryAdj, CoolantTempFuelAdj and the CrankingFuelAdj back to stock values as well as top charged the battery.
Thanks for the info. I have tried starting it with the global and deadtime set to stock with the same results. It will start for a second then stumble. And then refuse to start at all.
And yes they are hi-Z I have done the delete myself by soldering the 5 leads together and removing them from...
As stated my 1995 GST will not idle after I installed a set of FIC 1000cc injectors.
The car will start, run for a few seconds and then then die.I have verified that I have got the injbatadj set correctly. I have new plugs and plug wires, verified I have 43 psi fuel pressure while cranking as...
Thanks for the help! I figure out pin #1 on the receiver was not seeing switched ignition signal. Once I repaired that wire everything worked great! Sorry for the very late reply fixed about a year ago and thought I would update with the fix.
Checked the sensor on the driver's door lock and it is on good. And I tried holding the buttons a million different ways and still nothing. I only get the panic, so I know the receiver is working, just no signal from the receiver to the door lock relays.
So I returned the second control box and recieved a third that was pre programmed to a remote. Installed and all I get is the panick button like the original 1 I had installed, doors will lock if I use the switch in the car but nothing from the key fob. So I've narrowed the problem down to...
97+ method is the only one I could find that worked, and it did work on the old box, but once I put the new one in I cant get either to go into programming mode. The old one still sets the alarm off if I hit panic.And do you know which pins on the control box I should be seeing power on?
So I purchased a used control box and installed it and now I cant get it to go into programming mode. I figured the one I bought was trash so I put the old one back in and I can't get it to go into programming mode either. Is there a related fuse for the keyless entry or am I missing something...
1995 gst, just finished the awd swap and now that it's at my appt. I wanted to be sure it is locked up with the alarm. Purchased a used remote off ebay, used the 97+ program method and the remote connected but only the panic button works. Could it be an issue with the alarm control box or am I...