I've seen those but I just don't like the probe style. Not quite as accurate if you ask me.

i just want to keep it as cool as safely possible. especially when using my a/c. after doing some looking at how the switch is set up i don't think i will be able to wire it the way i mentioned but i am running my main power to my slim fans through relays so i could use it to trigger them...

i just wanted to get some opinions on an idea i had about re wiring my fan controls so they will come on earlier without using link since that upsets timing as well. i am thinking of starting with the vfaq 2g fan bypass but instead of using a toggle switch i was going to use this...

I'll have to see if I can trim the crash beam somehow a little different since my fmic mounts to the lower part not the upper as shown in the link above.As far as hood vents go what does everyone think of this hood? http://m.ebay.com/itm?itemId=191159242509

Dsmkauai please let me know which turbo blanket it is I'd really like to get one.As for hood vents is there anything similar to the rre one that's a little cheaper. It's $159 on there website.Cliff I am trying to do the impossible and keep the ac so I still have my condenser. I could try and...

I am running a 2g manifold with stock upper heat sheild. Since I have a bolt on bep on hx35 and recirc o2 housing I can't fit a sheild on there. Another idea I thought of is a turbo blanket but I have no idea what will fit the housing. I fabbed up a heat sheild out of aluminum to help keep some...

So I'm debating on a hood vent. High coolant temps are my issue. I can see temps of 203 in the morning when it's still cool out with a 160 thermostat with 10 degree offset in link. I am running an hx35 turbo and ets street fmic with ac. I am running the stock shroud in front of condenser with...

Seavee dsm how did your vents work out for you? I noticed on my way home after work on a 80 degree day I hit 186 on a 160 t stat no ac with some good pulls. I know with my ac before I was hitting 216

I have a derale puller for main fan and ebay pusher fan for ac, cx racing aluminum radiator, 160 t stat, 70/ 30 mix with water wetter maybe even more water than that, fans on constantly through link, fan shroud is sealed to rad, and rad is sealed to condenser.I am running hx35 on bep housing...

Engine Temps

I have been tossing around the idea of bumper vents to help bring down temps. I am running a little over 200 with ets street fmic and stock front ducts to suck air from fmic. I just don't think I am getting enough air flow. I have been looking into the 350z front vents on eBay and seen...

That's what I was thinking as long as I rotate tires I would be good. Time will tell

I went today and had an alignment done and for some reason my front camber differs from right to left. The left side is at -1.5 and the right is at -2.5 but toe was set to zero. On both sides. The rear is at -1.5 on both sides and set to -.12Is the front camber going to be much of an issue...

Just curious if someone can give me an answer on this. I've tried to run my car and disconnect one wire at a time for hooking up gm iat sensor. It isn't until I remove the black wire from my maf sensor that the car stumbles. So my question is can I keep the black wire on the maf and just use the...

After installing revised isc it's now operating as it should. It fluctuates some but I can get it to stay around 30 now so it must have come apart before I pulled it out somehow.