The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support ExtremePSI
Please Support STM Tuned

Recent content by Gizmo63T

  1. Gizmo63T

    ECMlink WBfactor all over the place

    This is actually my friends car. He uses FIC 850cc low z.We switched from SD to MAF and now car runs better, but MAF gets overran fast so that is not a solution. And we still have RPM line choppy. Injectors react better, no spikes. Is your RPM steady or choppy in log? We found that RPM line is...
  2. Gizmo63T

    ECMlink WBfactor all over the place

    On wiki it says that AFRRatioEst is using among all, injector pulse. Injector pulse is also going up and down, it is not constant.What can cause injector pulse to act like this?
  3. Gizmo63T

    ECMlink WBfactor all over the place

    Hello.We tried to tune 1g Eclipse with SD on dyno and we have a problem. I understand that the WBfactor should just give you information between WB sensor and what is in the table and tell you how much you are off from wanted value. WB sensor is reading constant value and it matches the...
  4. Gizmo63T

    1992 Mitsubishi Eclipse GSX 1GB project

    Gizmo63T updated Mitsubishi Eclipse GSX 1GBView updates to this DSM profile...
  5. Gizmo63T

    fic 1100cc injectors

    I'm using them and I didn't do any modification.
  6. Gizmo63T

    fic 1100cc injectors

    I'm using FIC 1100 high Z injectors in my Eclipse. http://fuelinjectorclinic.com/image/cache/data/incoming/image/data/incoming/B105HM4-800x600.jpgWe actually need high impedance injectors (that is why you have resistor pack with low Z injectors). So you could remove resistor pack and put...
  7. Gizmo63T

    1992 Mitsubishi Eclipse GSX 1GB project

    Hello. I don't know if this was your car, but here are some facts so you tell me :) -The rear lights had yellow indicator inserts when i bought it -I was told that the first owner was some priest in Italy -They changed the VIN number into A6076961A when they imported it back in 1992 -I didn't...
  8. Gizmo63T

    1992 Mitsubishi Eclipse GSX 1GB project

    Got a custum made pillow for my Eclipse :)
  9. Gizmo63T

    1992 Mitsubishi Eclipse GSX 1GB project

    Iveco Daily intercooler. The endings are plastic but it hold up to 2 bar pressure. Shipping for better intercooler from USA is a lot, so for now this is holding up very good.
  10. Gizmo63T

    1992 Mitsubishi Eclipse GSX 1GB project

    We went on a road trip. We do this every year and this year the rout was the longest (around 1100 miles). Rout was along our coast in Croatia.2 Mitsubishi Colt, 2 Eclipse and one Lancer :) Lancer had most problem (two :D ) tost clutch and dead alternator :) But we had lots of spare parts so...
  11. Gizmo63T

    1992 Mitsubishi Eclipse GSX 1GB project

    Ah yes, I did one other thing.Took out the stock rear LSD and swapped in EVO LSD. Aldo there is a bit much preload for my taste, but I'm getting use to it so no problem.I also changed knock sensor with brand new one, changed throttle body shaft seals and connected the clutch switch...
  12. Gizmo63T

    1992 Mitsubishi Eclipse GSX 1GB project

    Long time no write :)The weather is getting warmer, so does the oil in engine :) Decided to do something about it and change the stock oil cooler and placed it somewhere better.I also bought 160 thermostat so that will help also.Here is the oil cooler:Because the oil cooler is bigger...
  13. Gizmo63T

    1992 Mitsubishi Eclipse GSX 1GB project

    Back is finally tinted! :)
  14. Gizmo63T

    1992 Mitsubishi Eclipse GSX 1GB project

    Made first 500 miles of brake in. For now she is still on OEM maf, 450cc and ecmlink with basic setup. Soon she will go on speed density and proper tune up. Some of the SD goodies.I also bought from a member here EVO rear LSD diff. I just need to find some rear axle cups to make it work...
  15. Gizmo63T

    1992 Mitsubishi Eclipse GSX 1GB project

    Wheels are up :) Having a small problem with bov. It will be dealt with on monday. At the moment she is run on 450cc, maf and OEM ECU. After the brake in she will go on 850cc and ECMLink with SD.Here are some pic and short drive video.
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned
Back
Top