Sometime mail doesn't make it through the spam filter. I would replace that bell housing for it is too far gone and the distortion associated with that big of a repair would be a PITA to correct.Jon@TRE
We can fix it.If you want to send it here to be fixed send me an email, turn around times are about 2-3 days.More info can be found here,*****Also, I have a bunch of good used bell housings and other parts that are listed on the site. I usually take the leftover parts to the...
You will have to snip the Greddy connector off and stick the wires into the supplied connector.When it comes to polarity some manufactures use industry standard "Yellow is Pos and Red is Neg" but your wiring may not be yellow & red. If your EGT gauge doens't respond just swap the wires at the...
I really really doubt that you will ever break our spool. It very tought and features more spline engagement which will also keep the front pinion shaft from snapping at the splines.Jon@TRE
www.teamrip.com
The reason why I don't recommend the factory disc with the ACT is that the ACT pressure plate is designed to work with their disc.If one were to compare the ACT disc next to one from the dealership they'd notice that the marcel spring has more curl to it that the ACT. The further that the...
I don't believe it was that bad of a price and I never had one fail. $225 got you the rotated compressor housing, billet TIG welded WGA stands so the WGA was positioned just like the T25, ported turbine housing w/ bell ported outlet and the 34mm WGV. It looked as stock appearing as you could...
The EGT probe that we are selling is about the fastest EGT probe on the market that you will find that will last for a long time. It's response time really wakes up any EGT gauge and it'll actually show 200-300*F drop in temps between shifts.Jon@TRE
http://www.teamrip.com/accessories.html
Hey guys we are here and busy catching up on work. I have been working on the drag race gearing for the EVO transmissions and it's now available. There are a few transmissions over here that haven't been built as of yet and they'll be done within a week.My apologies to those who tried to...
You will have to put another wastegate actuator on there because the one in the photo is FUBAR'D.Also you will need to grind the weld off where the wastegate arm attaches to the shaft and reposition it. Keep the arm/rod close to 90* so it'll hold boost properly without any funky boost BS...
Hell if you can get them for $24 bucks a piece then send them here and I'll do the CNC machine work for $45.That way you can get them for $69 bucks, saving you $16 per fork or $32 per set.Jon@TRE