Thank you for the help. I did search the forums through the search function, and I went scrolling through this section to see if I culd find anything relivent. The NGK BK5RE-11s are they 13/16" plugs, or 5/8" because I cant fit 13/16" spark plug socket into the spark plug holes of the valve cover.
OK, so I searched through a lot of threads, and couldn't find the best spark plugs to use on a stock 2G N/T. I grab the NGK BPR6ES' cause thats what I use on my Talon, but since they are a 13/16" spark plug I can't fit a 13/16" socket down to put the plugs in. So what is the preffered 5/8" spark...
Car looks to be coming along great! Ive got to ask...what is up with the chamber in the IC piping? Ive seen it done before but never ventured to ask why its done, and what benifit's it "provides"...sorry to get a little o.t. :D
Those pics you snapped look the same way that my t-belt looked when I had the timing off a couple teeth. I didnt try to turn mine over at all because the t-belt looked like it had too much slack, so I re-did the belt, and re-checked timing marks (cams were off) so when I re-timed it the belt was...
ROFL YOU don't knife edge the crank, you send it to a specific engine shop that offers knife edging as a service, and they cut the crank, and balance it so its all good when you get it back.
No trying to be a smartass but how does grounding it closer to the crank make it better considering its a Piezo crystal in the knock sensor that when pressure is exerted upon it it releases electricity. I would thing that the ground wouldnt matter as long as its clean due to its only completing...
SBR has a nice stage 1 stroker kit for $1300. It comes with 2.3L crank, new or reman'd which ever you want. Your choice of rods, and pistons, as well as Clevite main/rod bearings. I personally like the ACL tri-metal bearings. They stand the test of being beat on, due to the steel backing, and...
Super ZStreet, or Modified did a test with a stock cat, test-pipe, and high flow cat. The test pipe only made +1hp vs the cats. If you face a fine I'd grab a hi-flow one, and you will never notice a difference, besides in your wallet that one time you get fined.
The 044s are -6AN fittings, and that pic that you linked is an 6AN to 8AN connector. It threads into the 044, and steps up the fitting to an -8AN so you can run -8AN lines. If thats not what your asking, then Im not sure what you are asking.Hope i was able to help. If not re word it, and Ill...