A few photos of progress the long red wire is the positive to to the battery for some reason the previous owner ran it super long for the battery relocation to the trunk will need to fix this
I’ve heard I just went with it because it was available and in my price range at the time. But later on I plan to upgrade once I have it running and find a decent priced one. I don’t plan on running it long.
Parts list
2.3 4g63 block
4g63 head
1g Crank dunno how that happened but it still worked for the build =O
Built Trans rated for 600-650hp
Stock Cam gears
Stock pulleys
20g turbo GSP
After market intercooler
Aftermarket intercooler piping
1g cam sensor
Injen intake
Greddy Exhaust
Greddy BOV
HKS...
It’s been a few months since I’ve posted or updated this post but have made some progress since last post. Will post photos later =). In the last few months I have finished the motor build and bought a built trans mission rated to hold about 600hp-650hp, granted my goal for the car is just...
I hope not if so then I only paid $300 for the shell most of my money is in the motor itself about $7k in parts labor and a built transmission. Could alway try and find a new shell to use. Was told by the guy helping on this build he could fix it hoping so if not I’ll save for a new shell
Motor and transmission are done gets dropped in tomorrow. Noticed damage underneath the car as well as some rust in engine bay no have to get those repaired 🥺.
Then I have a problem 🥺🥺🥺. They are bent up I talked to the guy helping me with my motor and he said he can fix the areas for me when he seals the two small rust spots I noticed in the engine bay. I just don’t see how it got like that.Well the rails are bent too I just couldn’t get a good...
So I bought this shell a while ago and don’t see how I missed this. As I am getting the car ready for to have the motor installed I noticed underneath the car was a bent up specifically on the side trim where you would normally put side skirts is this fixable?
t’s been a while since I posted on the site. I’ve been gather parts through patience and help from a member here on the forum. Currently the motor is being put together for me as I am on orders for the Navy and well let’s just say I got in over my head because half of what the previous owner of...
Just received these photos of my engine might should have went with a lighter color valve cover went with green because it’s my fav color. Think I’ll just have to get brighter color piping and coatings to make it stand out in the engine bay.
It’s been a while since I posted on the site. I’ve been gather parts through patience and help from a member here on the forum. Currently the motor is being put together for me as I am on orders for the Navy and well let’s just say I got in over my head because half of what the previous owner of...
Picked up my engine today and a few other parts I needed2.3l stroked 4g63t block with eco crank cp pistons,
4g63t head, pulley, water pump, water tower, gauge piller with Digital gauges, new filter for intake, starter, alternator, injectors.
Also don’t k ow if I updated last weeks part...