Alright letme tell you a little about the block. The block is fully built and it was resurface when it got built. The engine already was running a mls gasket( cometic) but started to push coolant not much but it was getting worse. When we pulled the head the block surface was pretty good. Now...
No, the head wasn't. Resuface on a belt. I know the shopand they use the high speed rotor I think is call . They done my head and other friends. I was running 36 psi and it was good. But like I said someone else did his head that time and it wasn't the old guy the does them all the times. His...
Hi guys. The block was prep properly and the head was torqued propertly as well. On the block there wasn't much to prep since he had a mls gasket already however I cleaned with one of those really soft green pads and it was smooth. Also I noticed that the head wasn't that much of a smooth...
hi, thats rommel holset short log... 27 psi by 3900 rpm untuned. we tuned the car a few weeks later and we ran out of fuel at 25 psi, turbo was flowing 52 lbs a minute.i will look for a complete pull and post it as soon as i find it.
I made 430 whp on my 20g 2 weeks ago. Had a bad boost leak and the car was breaking up.... i know there is a little more on this turbo. Hopefully i can get the most out of it with a intake manifold and a ported exhaust manifold for next dyno section.
Hey adam, I saw your car last night and we are gonna try to get together to help you out. I think you should check : 1 coil pack. 2 try to lower the boost and see if the car still acting up at lower boost. 3 change the fuel pump.
Well I can't take the burgers and bunn unless someone bring a grill and all that ### I'm not having meat and shit just laying on my trunk smelling and shit.... I'm gonna take drinks and call it day since nobody is even trying...
I will buy some burgers and bunns... we also gonna need a grill, charcoal, shelter, and maybe more food... where is everyone that said that was gonna bring things??