I had a 14b installed. It doesnt pull until 5500rpms and as soon as it spools is blows out tons of black smoke. During idle and lower rpms terrible exhaust fumes come out of the exhasut. I did a boost leak test and fixed all the boost leaks. I bought a MBC from SBR and hooked that up and it...

I need an engine asap and I can't find anything. Does anyone know of any one or place I can find a cheap engine. 7 bolt preferably. Thanks.

I am looking for different techniques on how launch my automatic tranny...Post the special technique that helps you keep up with 5 speeds off the line.

Thanks a lot. I appreciate the feedback.

Anyone know any local places in Pennsylvania to buy 7 bolts? Or Websites?

Im planning on ordering the autometer trans temp gauge and they make one that goes up to 280 degrees or 250. Will my auto tranny ever get up to 280 degrees????

Has anyone ever had a bad experiemce with an eBay exterior door handle?

How do i tell if the wastegate is working properly? As of right now the car is way to hot to play with right now. I can check it tomorrow before class.

I had a 14b installed. It doesnt pull until 5500rpms and as soon as it spools is blows out tons of black smoke. During idle and lower rpms terrible exhaust fumes come out of the exhasut. I did a boost leak test and fixed all the boost leaks. I bought a MBC from SBR and hooked that up and it...

I didn't wonder until I tried every little adjustment and it still doesn't work. I blew air through the controller, you can only blow air through one way, so I have the nipple that recieves the air coming from the BOV line. I tried both way but neither work.

I'm running a 14b set-up, does it have the compressor housing nipple?

SBR MBC1. I put a "T" in the line running from the BOV to the Intake manifold. 2. Unhooked the hose running from the wastegate solenoid to the wastegate and capped the nipple on the solenoid. 3. Ran a hose from the actual wastegate to the MBC.The boost controller will not work. I...

Thanks for the info, I appreciate it. But I called both numbers. Customer correalations of Mitsubishi stated that the car was inspected in 2001 and the ball joint was sealed. I argued that point and they said they cannot assist me any further. They transferred me to the auto saftey hotline...

My ball joint is just about to snap apart. I know there is a recall on these for 2g's, but i never got the notice in the mail or anything. So, I called the mitsu dealership and asked, they ran my VIN number and said that there aren't any open recalls for my car. Is this possible or do you...