TPS & base timing are set propely but just stopped and there is no control on it.TPS < 1%
Base Timing 0 degreesIdle % vs Target table does not work. I mean, if I do any kind of change in the idle tap, nothing happens. That's my problem. It has the calibration setup but I can't adjust it...
SorryThat's my tune, file above drive linkThe car is running but idle problems, bad idle cold starts, no A/C adjustment, I did the screw adjustment warm engine to get stable idle at 1050 rpm.I already tried AEMpro 450cc calibration file and idle just never change. the IAC Valve is good, I...
ok, this is my street tune. I just escale the map to use 550cc evo injectors. However idle valve does not respond to the software. Idle % vs Target Table does nothing. Also pin 7 that is supposed to work with switch 3 for A/C compesation does nothing. The oem A/C request works positive signal...
Does anyone know what's the AEM v1 PNP 1g board circuit?I'm having some problems with the idle. When I try to change something it does nothing. I already replaced the IAC also check vacuum leaks. All good. The problem is something in the the board I thinkThanks
Hi guys I see some people running bkr7 spark plugs. But the ceramic of the spark plug is a little smaller than BPR spark plug models. Can I still use bkr spark plug with the stock spark plug wires? Is that a problem?
Hi guys,I've been reading about flex fuel,I just want to know more information, if someone has done this system swap, if there is a guide of something.Thanks