The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support STM Tuned
Please Support Morrison Fabrication

Recent content by Ejsmith50

  1. Ejsmith50

    1G Shift Solenoids Bad?? Replaced But Still Have TCU Codes...

    Thanks for the info & link. Had the four wire plugs switched, because the one for solenoids was too short to clip on holding bracket, so I didn’t think it went there. After checking voltage on both 4 pin connectors, I found that the pulse generator pins had 2 volts. Then it made since. Now kills...
  2. Ejsmith50

    1G Shift Solenoids Bad?? Replaced But Still Have TCU Codes...

    Hello, I have a 1991 Laser LS stuck in limp mode. Have codes 45,47 & 85. No ecu codes. Have a bunch of hours researching this. Tcu is fairly new. Trans works fine on home made simulator switch. Has correct volts on each pin on inhibitor plug and ohmed inhibitor switch, also fairly new. Haven’t...
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned
Back
Top