if this side is gonna delete my post that was posted in the right section, with info people should be aware of, go a head and delete my account.
I'm not gonna waste my time here if thats how the site operates now.
i would think the 2g euro-spec transmission is basically the exact same as the 2g GST trans. If anything is different, i would assume would only be the gearing and/or clutch assembly.
the impact sensors are under the fenders. around where the headlight and fender meet.
I would make sure the clock spring and airbag on the steering wheel are connected. seems more likely than the impact sensor
on the passenger side the impact sensor splits off the harness in the same place as the turn signal bulb.
on the drivers side, its the plug after the turn signal bulb
they are not the same.
if you have a 420a flange and try to match it to say a 2.4 spyder header, it doesn't work that well. but if you have the opposite a 4g64 header flange, you can mate it to a 420a runners if you cut them right.I can get you measurements of some sort. Ill get them up...
so the only difference between those injectors and the ID injectors for your car will be the lower seats.
those have a 14mm o-ring seal, the 1g/2g ones have a denso lower cushion for the seal. If the injectors don't seal with the 14mm o-ring, it looks like you can cut off the plastic retainer...
you need the switch, relay, foglights with brackets and the bezels. You can probably cut you stock bezels to work if you'd rather do that.
i know the 98-99 cars have the plug for the switch but i'm not sure about other years, so you should check to make sure you have it on your harness. same...
was the relay clicking on and off?
if it was, try swapping out the relay. if that doesn't work check the ground, if thats good, next time it won't start, check to see if its getting voltage at the (+) side of the coil (86 on the diagram).
if your looking for flange bolts, you can always get them from honda
70mm part# 90051-PE0-000
130mm part# 95701-12130-08not too sure if the 160mm bolts have a 17mm head cause they are for a motorcycle so i haven't actually seen one.
160mm part# 95801-12160-08