Ok so i installed my new maf today it did the same thing but i gusse my car was acting funny because while my car was at the garrage the battery was taken out so my ecu was reset. So i had to let me car idle for a lil while and drive a couple miles so everyhing went back to normal...Thanks for...
When a maf go's bad are these signs of a bad maf? The bucking and unresponsive throtle response..beause like i mentioned before the car drove fine with it unpluged but once i re'enterd the plug it started to slowly idle down and bog ready to shut off. But when it wasen't pluged it would idle...
I just picked up my car today at the body shop backed out of the garage and pressed on the gas and the car bucked and studderd alot but hardly went anywere. I got home safe but it was very hard to drive the car. At first when i started the car it was idleing funny and boging almost shuting off...
Yea i did i will post pics as soon as i can. If anybody has done this mod before fill free to wright up your information or pics if you have any. thanks
Hey, I was wondering if a steering wheel from an Evo 5-9 MR will bolt on to our factory hub? For a replacement from our factory wheel... thanksI've seen some pics of other dsm's with one of these so im just curious.
Im having this problem with my antifreez for some reason i had the car on for about 20 minutes and had the heat on blast but no heat.. The car was not over heating and was idleing fine. Its bin sitting for about 2 months but started up fine. I removed the radiator cap and it shot up at me with a...
Yea sounds good i'm just going to have to go with a 60mm throttle body. Maybe some other time, i have some more part's i want to install befor then. Thanks guys
ok so if i stick with my stock oem manifold can i still go with a 1g throttle body i thought those were alot better for our 2g,sand ive seen on this site and off most 2g guys go with a 1g throttle body i thought it fit right onthanks for the information this helps alot
im going to switch my intake manifold and TB to a 1g IM and 75mmTB but im just wondering if i can get some information on the install and what would i need for the install if any of you dsmers done it befor witch i bet you must have....:D how was it and what kind of gains did you get from the up...
help will be strongly appreciated...i was in the process of changing my rear brakes then this happens the lug nut key i have for my lug nuts snaped in half inside my rim i tried everything i can think of in trying to remove this peace from the hole but cainti was told to take off the...
im running 8's gapped to 0.28 and i havent had no problems boost fine and runs smooth....i wouldent give it to much thought just go with the 8's since your running high boost and you have a big turbo they should be fine....good luck bro