Do you happen to know the torque for the front cover

Awesome that helps out a lot! But it doesn't show all the other bolts...

I have the new pump on (not bolted) just wanna figure out where everything goes.

Talking about whole front cover

Okay so I found my box with all my old tensioners,water pump, etc with all the bolts but I still don't where they go... I had them put with what they went with but must have fallen out when I was movin the box around.

Okay I can not find this info anywhere. I'm about to put my oil pump on but I have (5) short bolts with the number 4 on them. I know they go with the oil pump but I feel like there should be more bolts for the extra holes. It's been 5-5 1/2 months since I took the motor apart(machine shop took...

Okay I'll re-measure. And I'm getting a hx35 off my friends cummins for free! Lol

Okay so just run with the rings or what? No one really answered my question haha

Well they're ITM pistons, basically oversize oem pistons, if I'm correct. I read ITM made the piston for mitsu so they're basically oem? And all stock internals yes.

So for it to be bored/hone .020" over, deck to clean,jet wash, put piston on rods, and order new pistons it was 574.85

It had a pretty good ridge at the top of the cylinder, and the machinist said it'd be best but that was the machinist who lied to me about prices and shit then the shop fired him and then I call to pick it up a week later and they tell me he's no longer there and the real prices of the work...

It's a 6 bolt. It's just a stock rebuild so I can drive it honestly. Down the line it'll have dsmlink and hx35 with supporting mods but not for awhile. And I put the rings in the bore one at a time and pushed them down with the piston so they're flat and square in the bore and used a feeler...

I have references for the specs on ring gap but since they're to big what do I do? New rings or? It's all brand new itm piston and rings. I do have another set of pistons with rings maybe I'll give those a shot

Alright, so I finally got my block back had it bored .020" over. I was measuring ring ago last night and it's big but not past the service limit .031". My question is can I get by with it or what should I do? Here's what I got. I'll double check the measurements later if need be.Ring gap...

One word.... WOW. This is an awesome build! I wish I knew about those aero kits when he was selling them, i love the look and functionality of them. I keep checking to see if you added anymore updates, to anxious to see the finished product. Keep up the awesome work man!:applause: