I have been still trying to find out why i have a no start. I have volts going to starter and not sure if its a ground problem but i have checked them. Also had the starter relay go bad. Now car cranks but no start. I took a videos of what it was doing.
I will check all that again. I have checked but wont hurt to double check. I will get a friend over to see what the volt are when I crank it. I have been fighting with it for awhile now so just need to get done. Thanks for help guys. Will keep you posted.
ok the battery has 12.09 volts at batt. tested at the two cut off switches i have and they both have 12.09v. i tested all way to front to where i relocated my fuse box under dash has volts there also. tested the two ATL and the starter wires they are both good as well. I didnt have anyone here...
Yea it is the starter relay in middle were stereo goes. I'm making a jumper wire today to see what happens. It's a new battery I just got as well as starter. I will check volts cranking tonight.
I have battery volts of 12 volts or more in battery. I also replaced old starter with new it wasnt engaging. The starter relay in middle is clicking. I have volts to starter. My fuel pump is wired to toggle switch and that stopped working now also.
li have a 2g and i currently tried to put ecmlink in and i try to configure live but it will not connect to ecu. I am not sure what it can be i have read a few post already. anything helps thank you.
On my eclipse my hatch brake light is staying on and also my brake lights. I can take fuse out and it will go off. I put back in it goes on. Even if the hatch is closed the light is still on. My dsm is a 95 eclipse gsx. I did a conversion and got a hatch off a 97-99 eclipse. I look at wiring...
I will check that rubber piece for the pedal. I am going to look again see if I can find a short to ground. This brake light problem started after I switched the hatch over. It's the brake light staying on though. Thank you for all help will keep you updated
Did a 2ga to a 2gb conversion on my gsx. I bought a complete hatch instead of drilling holes in 2ga hatch. My tail lights are staying on even when key off and out. I'm thing there is a short to ground. Any help will be great. I checked the lights took them off. Not sure