Alright, thanks for the input guys. Connectors seem to be the general consensus here, I’ll get goin on wiring them up.:hellyeah:

Just looking for some insight on this.This week I’m going to be wiring in a new set of radiator fans; however, I can’t use the connectors for it.My passenger side fan connector is completely fried and my drivers side one is gone. (One of the past owners removed it and soldered the fan...

I would return it, but they came with the car when I bought it. Figured I’d see if I could find a way to make them fit before going out and ordering a new one.Yeah, that’s the thread I found after doing a little digging into this. Some pretty helpful stuff. Also some pretty confusing stuff...

Anyone ever had to flip their Compression Control Arm bushing?I’ve been replaced my CCA’s today with oem ones since the ball joints have gone bad. I started with the passenger side and everything fit perfectly. Ball Joint lined up, and the mounting bolts did as well.Switched over to do the...

Update time.Good lord this car just drains my wallet.Figured out why she would just crank. Trans shop apparently didn't realize my intercooler's cold pipes actually needed to be connected to the charge pipe. Basically it was one big ol boost leak. Super easy fix. Trimmed the inside on my...

Try checking out this link. It details almost every common reason preventing a startup. Lots of people have been able to get their cars running with the info on here. If you go through the whole list and there's still no start, then there might be a bigger issue at hand. Hope it helps...

Thanks for the link man, I'll give that a shot!

Being completely honest with you, I've got no idea. It's just a crappy plastic pipe that's been the bane of my IC system since I bought the car.Yep, and I hate it haha I'm gonna upgrade it sooner or later.

Figured I post this just to get a feel for how you guys would fix this.I’ve got an annoying issue where my Intercooler piping keeps popping out of its clamps. Specifically around where the air filter/fuse box is located, just in front of the passenger tire. Between the top and middle hose...

I’ll for sure check into it. I’ve got some new parts hopefully arriving tomorrow, so I’ll knock out a leak test after doing the installs on those.Sounds like a good weekend project to me. Thanks for the heads up.

Went out and got a new sensor installed. New pigtail soldered in as well. (For reference it’s an SMP S820) Looks 99% the same, only had to sand down the left side rail on the sensor and it hooked up perfectly. Should work for now.Cleaned and dried the plugs, charged up the battery, reconnected...

Kinda confused about this one. I’ve got a 97’ GSX that’s cranking, but doesn’t start. I took it into a pretty well reviewed Trans shop for a total rebuild, and the car fired up no problem before they started taking things apart. They got the trans dropped, rebuilt and finished, but low and...

Alright alright alright. Got her back from the shop finally. Transmission totally rebuilt. Shift Kit completely installed. Everything's finally coming together.Syke.Once the rebuilt transmission was put back in, the car immediately refused to start for the test drive. It just cranks, and...

It’s been awhile since I’ve been on here, but I figured better late than never to post and update. Been hammering through some serious maintenance to the car, apparently none of the 6 different owners before me ever thought about fixing problems instead of adding expensive mods.I’ve gotten...

Working on getting the car out of the garage. Haven't been able to keep up with her since Fall Classes started. Money's been short due to being moved to part-time at work. No income + No time = No progress.BUTGiving up isn't an option. The Trans is still shot, and the interior is still...