I need a machine shop to get my 4g63 block and head worked on. Looking for any recommendations and/or shops with experience with our stuff.

I need a machine shop to get my 4g63 block and head worked on. Looking for any recommendations and/or shops with experience with our stuff.

I need a machine shop to get my 4g63 block and head worked on. Looking for any recommendations and/or shops with experience with or stuff.

I need a machine shop to get my 4g63 block and head worked on. Looking for any recommendations and/or shops with experience with or stuff.

I need a machine shop to get my 4g63 block and head worked on. Looking for any recommendations and/or shops with experience with or stuff.

Can you guys guess who has 113psi of compression (at best), two thumbs, and just filed his taxes? :aha: Anyways I would like recommendations as to any complete rebuild kits to get and any reviews if possible. I wanna get about 600whp and would like to keep the internals as stock as possible...

Very interesting, did these bushings require any modification or was it a simple install?

Any one out there tried the VFAQ rear camber bracket fix?

I'm fairly confident that the shocks are stock. I cannot tell if they are bad though, the springs are too tight. Good point though, the shocks and bump stops are items I haven't considered. I have a spare truck I can use as a DD so the car can be down for a bit and I was planning to rebuild the...

I purchased my 1G back in October and it has 235/45R17 tires with EVO VIII 6 spoke ENKII wheels. One of the previous owners has installed lowering springs at all four corners. My best guess is that due to the 2"+ drop and whats left of the spring color, these are the ones installed but no...

Mach V has a nice kit for just south of $500 and has everything you need for the bottom end minus the timing belt and tensioner.Mach V rebuild kit

DSMKauai is quite accurate. However, Charging the system with R-134a/R-12 without an A/C machine to recover it afterward can be expensive. Assuming you don't have access to $2000 A/C machine a cheap and eco friendly way to charge the system is with nitrogen. It wont cool your system but the...

:banghead: :ohdamn: How many times do I have to repeat myself about the CTS? Unpluging it made the issue worse so it is not bad.

I pulled it the other day, it is a non-EPROM stock ECUI never did remove it but it unplugging it did make the situation much worse.I don't have any extra injectors lying around unfortunately, however, after doing some research I am convinced they are stock. #1 they look like the stock...

So as far as the idle it is still a little erattic. I'm getting DSMLink V3 soon so I can eliminate the idle switch and find out if its the idle motor or not.The cold start is the bigger issue at the moument. I thought that I was flooding the cylinders so I have been letting it sit longer...