Long story short I have a 90gsx that had a bad transmission in it. So i purchased one out of a 95 gsx which came with the transfer case. Everything bolted up just fine.So i start driving it to put miles on the new act 2600 clutch and make sure everything is in working order. One of the...
I have a 90GSX 5spdBought a 95 AWD Trans/TcasePut in New clutch Disk along with new Redline FluidsWhen doing an initial test drive, after 10min or so, the car is showing symptoms of a "slipping clutch".Ideas?Car also has 1g slave cylinder.
I just installed a b&m oil cooler and after the fact i saw the instructions on which way to mount it....I have the lines on the bottom (facing the ground) I'm not sure it really matters but would like some piece of mind.
I am finishing up my 6 bolt swap on my second gen. And I have the coil packs off of my first gen. I was wondering if they would work for my second gen. I think they have the same plug.help..
I am in the middle of doing a 6 bolt swap on my 98 gsx.
One of the things I was wondering is if the knock sensor from a 1g will work on a 2g. They have the same connector, But I do know one is an OBD1 and the other is an OBD2 car.Help! lol
i am now the proud owner of a t3 3in vband. with a boost logic welded vband downpipe.going to make a build thread on the car should be done in two or so weeks