The ecu uses 255(0xFF) for the max TPS value(5 volts).For % you would use: x*100/255For Volts you would use: x*5/255 or x*0.019610.01952*x, is very close, but might be off a millivolt or two.TPS RequestID is 17.
Many of the flashable ecus are interchangeable.The 4 cylinder H8 ecus are divided into two groups:
Emissions compatible / USDMNon-emissions / JDMA rom from the same group will most likely work in an ecu from the same group.But there are some hardware differences that cause...
Enable boost control.If you can do boost by gear, just lower boost at lower rpm and affected gears.
(Where you are having surge.)Compressor surge is caused by the turbo spinning up to fast and crossing its surge line, not by back pressure. Although a larger hotside will slow down...
EvoScan data.xml is in the CeddyMods .zip file.In EvoScan_2.7+ folder.No need to setup MUT Table, 2-Byte Load, etc.Its already all done for you. :)Edit:Didn't see you have EvoScan 2.6.
For that version its in EvoScan_2.6- folder.
Upgrade to at least 2.7.0090 for working Maptracer...
I have not tried it myself.People report they get low rpm engine vibrations and knock.Its kind of hit or miss if it works or not.You could swap a 1G CAS on, but I believe the 95 camshafts need the passenger side threaded to accept the 1G CAS.A 97-99 would also work but I'm...
http://ceddy.us/h8-ecu-wiki/roms-ecuflash-defs/2056-0008
and
2056-0010are both there for download. (2056 is 98 AWD)But your stock rom may be a different subversion.
There are about 5-10 different subversions for every year.Most people just use a CeddyMods rom, you can...
You can't run a GM MAF without out a Translator.The GM MAFs frequency output isn't compatible with our ecus.Even with DSMLink you need their cable/translator.
All DSM Plastic Case ECUs are Flashable.The only exception that I know of are some early ACD(Active Center Differential) ecus must of been a prototype run and have a Hitachi H8/539 cpu, not the Mitsubishi variant of that cpu.The H8 ecus(98-00 or 01) can come with the MH7202F or MH7203FA...
The stock EvoScan EcuLoad will only go up to 160. Which is only around 7 psi.If you switch to a CeddyMod rom, and use the included EvoScan .xml there are addition Loads added to log.1Byte Load is the best(fastest) to log.[1Byte Load maxes out at 320 Load, ~30 psi]A few of the...
Its strange that you need so much MAF compensation. Usually you just need to enter Injector Scaling and Latency and you are good to go, MAF Smoothing is more just for fine tuning.http://ceddy.us/tuning/injectors/
Is back up with pics. But I need to update some things, mostly the Fuel...
MAF Smoothing adds or subtracts fuel at different Hz levels.It has a nice % scaling.So 110% = 10% more fuel.I prefer to use MAF Smoothing to adjust fueling.And use MAF Scaling for swapping to a Evo or other MAF.