Still on the hunt for a 2ga engine harness. Is there anyone who builds/repairs harnesses? I know ohms racing makes some sweet harnesses but it's at a cost of course. May be worth while to leave it up to them though because I just don't have the...
Well. If it's a 2.3L you have the Loadscale wrong. In direct access, go to the loadscale tab and change the value from 100 to 87. You will have to do this with the engine off.
Did this. Decided I wasn't gonna wait any longer, and actually moved the car under it's own power. :hellyeah: :hellyeah: :hellyeah: :hellyeah: :hellyeah:
Put in an authentic GM 3 bar and took it out for a drive. For some reason when leaving 1st it’ll just bog out if I try to give it gas. If I don’t and let it limp on its own it’ll eventually get going and once moving it’s fine. Noticed I cracked...
More work done.Bench bled, then installed the slave. Then bled the whole clutch system. Popped the exhaust on, then swapped all the cables and shifter assembly over to the 90 model.Bam. Also painting my little center grille piece that’s...
Pretty sure step height on this flywheel is incorrect. Me and Paul Volk both have the same exact issue and both have unused ACT Flywheels.Tim Z in my build thread stated he measured three new act flywheels at his shop recently and they were...
Dropped the t-case, helicoiled the stripped hole(it's janky, NGL, but it works), bolted up the inspection plate, then threw the t-case and axles in, and proceeded to fill the rear diff and t-case with lightweight shockproof, and the trans with...
I FINALLY ASSEMBLED MY ENGINE, tack welded the timing belt metal cover plates that had split apart, painted them matte black to match the VR4 black cover, installed the new dimpled/slotted EBC rear Rotors, reinstalled the calipers, and had many...