I added a front carbon fiber vent to get more air to the radiator (fmic blocks the bottom opening) got a lower temp 180 thermostat and I placed duct tape to seal the side gap between my mishimoto slim fans and the oem radiator and (*knock* on wood) the temp gauge hasn't gone past the middle...

I love my a/t 2g GSX.I have an ipt transmission, Ipt high stall torque converter, Dsmlink v3, 16g turbo,Dyno tuned.Pulls hard and is a fun drive.

The front opening for the fmic looks larger than normal. I was just wondering if you trimmed it to get more air.

Pictures please!Looks legit; I am sure it brakes like a dream now.I love the front vent you made for the fmic. How did youmake it, an do you have more pics of ityou could post? and did you cut the side for the piping?

I had the Sony deck rewired after the old owner did it wrong, got front speakers installed, and new tweets. Sounds much better now!

Great times! From the look of your engine bay you have done your work! Clean and quality parts; not bad!Any overheating issues? What radiator/fans setup do you have?

So I had a new thermostat but in, but the two mishimoto slinking fans: only the one on the passé get side turns on for cooling. The one on the driver side only turns on (now both pulling air though) when really bad, by which point it is usually too late or slightly overheating.Anyone know a...

So I am at a local shop getting an alignment dne and they said they can completely remove the thermostat to help the system from overheat g. Has anyone else done this?

So I had the fans fixed and rewired so both pulling air through the radiator now. So instead of pulling air from the burning hot exhaust manifold towards the radiator, the air is pulled from outside the bay and blows towards the manifold.Also I had the coolant flushed and replaced, added...

Hey thanks for the quick response and tips. Do you run both fans as pulling? How many other people do vs one fan push one fan pull?Have you pulled the seal yet? I ask as I live in Boston so part if me would be worried about water and snow getting in there.

Hi I searched and checked under FAQ but couldn't find an answer.I bought some mishimoto slim line aftermarket fans. I have a EVO III 16g and the top heat shield over exhaust manifold.1st question: push pull combo is best, but right now the fan is pushing air towards the radiator so pulling...

Well cheap stigma aside, the Evolution is holding value and has proven to be reliable and a top performer at any price.Sometimes you do have to "pay to play". If you don't like the price, don't buy it. But if you don't find it at the price you like, the market might be higher than what you...

:hmm::toobad:If I owned a 20 year old Corolla, perhaps a maybe. But in a performance engine that runs warm, and boost? Not a chance. FUll synthethic (new) all day everyday. :hellyeah::thumb:

Where does link say 330? It may be near that (crank is probably over 300,) but with the automatic and AWD drivetrain loss, 220whp seems like it is on par, correct? I ordered it from DSMLINK directly for an automatic GSX. How does one go about changing it from the '5 spd setup' to an automatic...

If you are sold on it, then search for a quality used one, or buy a junked one and literally have a few extra thousand saved to replace/repair improve what you need.Welcome, there is a wealth of knowledge and advice here. Good luck!:rocks: