Ceddy mod...uses rear o2 simple and you lose nothing!

for simplicity go with the evo 8 vs the 9 and don't waste your time with 98-99dsm ecu.If you want the best H8 ecu for future upgrading go evo 9. But its a few more wires to switch and maybe a check engine light!oh and have fun!

Just a few question if you have time! just having the balls to tackle this job i'll give your props. With that said if you have the money and not rolling pennys then its a hell of a lot easier! i would have bet money chop strand would have been heavier. :DWhat weight of mat are you using...

the 1.3D cable will log twice as fast as the open port 2.0 cable (which you need to flash a 98 ecu) 1.3R cable can flash a evo 7.8.9 ecu but not a 98 dsm.the R- is twice as much money as the Dyou will need a 1.3 D cable and an op2.0 cable for a dsmSo find an evo 8 ecu and swap...

really just to save a buck?

you will need an evo 8 or 9 ecu with tephra mod, this will give you dual 30x30 maps and you will need an Aquamist meth injection system for any fail safe options. They work together and there is a lot of support!the best meth system on the market!

no drivers for my usb to serial....on 8 64bit! on mac with parallelsdidn't try 32bit and didn't try with pc

I Agree When i first read it, i felt he was just pointing out some good info! I also was unaware there were two different sizes :thumb:Could have been written better maybe but hey its a car forum!:D

thanks ya i took a look at his site and thats exactly what i needOUCH rotors $160 each!

these are the old style conventional mounted callipers!

I have an old set of Wilwood with the .80 thick rotors that don't last very long. i picked these up a while ago and they need new rotors.The old rotors measure 13" and are a two piece design. However Wilwoods website and catalog don't have any info on these and are discontinued.Does...

Also make sure you don't have a boost leak or else tuning with be really hard!

stock 7 boltevo 3 intake, FP exhaust mani, fic 650 3" exhaust e3 16G HKS 272 cams, BBK TB, PR FMIC, and meth. running 25 PSIThis setup pulls hard!I thought i read you had a 16g.....why don't you?? they are cheap!

on dyne results i've seen just use blue -40 washer fluid cheap and available, at least in Canada!

what does the low oct map look like can you post a pic. ?