Found at least what I think is the issue. More investigation to ensue, but here’s what I found.Fuel injector latency was set incorrectly.
I have FIC 1050cc low-Z injectors and found a previous data sheet from another member to reference to...
Difficult to rule that out honestly. Car has been sitting all winter with about half a tank so it's possible. Although, it's fairly consistent after the car is driven and warmed up for about 10-15 mins.
Posting this log for historical bookkeeping.
If anyone has any advice, this would be helpful.P0300 code came on at 723s into the log.
For me, there does not appear to be any kind of trigger, so I am struggling to diagnose the cause.
Hello Everyone,I am running into an issue that I have not dealt with before, and I am not finding a good starting point through my searches.Car is recently rebuilt with a 6 bolt in a 96 Talon.
ECMLink V3 installed.
GM 3.5in MAF
GM 3 bar MAP...
Update 4/17:Car got back home last week and I tried to make quick work on some things to get it put back together.First step was painting the cage. I just used Rustoleum oil-based enamel in smoke gray. It was a challenge to lay down but...
Damn! Been a minute. Got a bit of stuff done. Picked up a heat barrier gasket and a bezel insert for the fueltech from Jason. Super cool. Got some of the suspension together as well. Installed the rack and the RMDSM front sway bar. Also got...
Yeah thanks for connecting on Discord!
I do wonder how you got all of your GL stickers - did you have them made up locally or just pick up from the track? I need to get a file made for GLTC stuff, I'm just not very handy with all of that.
Schedule is looking like this over the next few weeks.
- Get car back this weekend
- Paint/reassemble interior
- Dyno tuning on April 23-26 at Pure Tuning in Toledo, OHOnce it's tuned, will get suspension sorted for the GridLife Rev Up event at...
The cage is not going to be FIA certified, although I do know the rules well. The FIA bar was just an addition I made. This will be made to race with SCCA, NASA, and GridLife, and this FIA bar is above and beyond those rules.
This is also still...
Update 4/4Should be getting the car back from the roll cage installation but too excited to wait, so here are some more in-progress pictures!Back half of the cage, out of the car to be fully welded.Rear down tubes are placed up on the...
Haven’t been able to get out to the garage too much lately. Just life stuff going on. But, I brought the dash inside and started working on the fuel tech setup. Really impressed by how much the fuel tech can actually do! TONS of available inputs...
Update 2/12Small update from this weekend.
Roll cage was started progressing.
The base plates have been fabbed and are tacked into position.The seat mount has started and that took a turn almost immediately. We found not just one extra, but...
Update 1/27Last couple of days have been pretty big!
Finally got the car out of the garage for the very first time. Ran it up the street once and immediately turned back around. I am sure there were a few loose suspension fasteners because...
ISO:Looking for a rebuilt or good condition 1G throttle body, 91-94.
Will rebuild mine in the future but need to get the car running and dyno'd soon.Please PM me with info and price.