I ran mine to the rear bumper. 4" aluminum from down pipe back it was quite difficult getting around the rear axles and it ended up being extremely loud. We made the the muffler from 5" and a 4" perforated on the inside with glass packing. Still was extremely loud and tends to turn into a...
Vader fuel pump drive on exhaust cam and looks to be a mivec setup on the intake.Nice use of the 6 bolt girdlesSo is the laser done or is this just a spare motor.Just read above. Thanks for all the inspiration never saw the car in person but always kept up with what you did with it.
So been a while got a lot of things going on but i do have some up dates. I purchased a an aim digital dash and a mako motorsports dash insert made for the aim. It looks awesome. And will give the setup a clean look.
The car absolutely stunk. And had rat bed and defecation in places i am finding are very hard to remove. I have got the car cleaned back up. Im about to start rewiring the entire car. Doing a stripped and condensed setup for drag racing.
So the engine is assembled. Now time foe some rewind. I have had this car since 2004. After my first build as a street car. I decided to cage it and set it up as a fwd drag car. I finished the setup in 2010. And pretty much parked it. Except two trip to the drag strip in 2010. Well after 10...
Oh dont forget if your looking to get 1000hp with 86 mm pistons you might want to consider having the block at least half filled. While it will certainly do it. It wont last. Been there done that.
There is also the option of wiring diodes directly to the soleniods with the diagram on kiggly racing site. But that leaves you to manually shifting the car from that point. Its what drag racers do.
They will still make a new harness if you commission them to. But they are expensive. So if you have a picture of either side of the connector they should be able to get one. I would think.