Doing fuel pump today. Walbro 255. Went to pull old one and noticed it too is a walbro 🤣🤣🤣🤷‍♂️ oh well newer is better right?

My bad

Quick question because I couldn't find any info. I did the egr delete and canister delete but what do I do with this extra hose with inline filter/check valve? (Not sure of which it is)

lmao gotcha bro. I've been here for some years but i consider myself a noob still LOLLOL:hellyeah:

Should work just fine for you as long as you have a way to tune. I've heard nothing but good things about fuel injector clinic.

Evo 560cc's out, FIC 1200cc's in with resistor pack! Spring break coming fast!

Can't stop won't stop 🤣🤣🤣🤷‍♂️ turbo is in! NO EXCUSES

Also got turbo ready to drop in. Justin whitesell built 20g with some upgrades, fp mani, open dump O2

New water pipe o-rings installed along with thermostat housing gasket. Cleaned water pipe best I could without removing from car

Got "shop" cleared out and pushed car in! No more excuses time to thrash! Hoping to have her back together for spring break

Finally got some decent weather so figured id get started putting everything back together. Tight fit but it's in. Quick question. Thermostat housing... gasket or rtv? Either or doesn't matter? I've seen both used but nothing really preferred over the other.

Haven't been able to do much work TO the car due to crappy weather the past few weeks. So while the weather is prolonging things, I've decided I'm gonna clear out my garage and make room to roll her in there so i wont have any more excuses LOL. Cant wait to get her all put back together and on...

Turbo finally arrived! It's a Justin whitesell built 20g with some upgrades. Time to start thrashing to get it all put back together.

More parts incoming! Walbro 255 and speed density bundle arrived today and my injectors came Thursday. Still waiting on turbo.

Haven't done much to the car itself. Just been ordering parts from my wish list. fuel lab afpr, FIC 1200 hi-z injectors, and Justin Whitesell built 20g with billet compressor. When all that gets here I'll start thrashing on her some more. Still have other parts on the table waiting to install also.