Having a hard time pinpointing where the noise is coming from but it sounds like it's coming from the engine bay. The noise almost sounds like belt squeal (like a rubber on metal contact) but only occurs under deceleration when the engine is bucking going into an engine brake. The squeaking will...
So its seem that 450 whp has been done a few time I think I'm more worried about the tranny at this point. @renovatdkitchen I believe XTD stage 4 is rated up to mid 450 ft/lb of torque, so getting close to the limit but I have read people running even more power through them with no problems.
Hey guy, I know this has been covered in a few threads but I didn't get the exact answer I was looking for. I currently have a stock 7 bolt with 134k miles on it, 175 psi compression across the board. It ran 329 AWHP on a mustang dyno with a 16g @ 22psi on 94 octane with meth injection. For...
Why don't you just T the factory oil pressure sensor.
http://www.dsmtuners.com/forums/articles-engine-fuel/359004-using-t-install-oil-pressure-gauge.html
Well if you can live without the progressive controller you can wire up pump into the FPS or EGR and use the meth under DSMLinks nitrous control to deactivate it between shifts and on launch.
Seriously man I bought my first DSM also at the age of 17 (I am now 18). You have a lot of learning to do, I would really start by reading around this forum. I learned a lot just by searching. Almost every question you have asked could have been easily found by searching. In regards to the...
Ok thanks, I'll try that tonight. I will update after it is done.*Update spliced into the brown wire and it worked! Awesome having a working gauge, many thanks snowborder714
Yes I checked it again with version 3.15. All settings were retained. A/F ratios are bang on in the ecu and line up with A/F est.Would extending wires for the db gauge cause any problems? There all extended maybe 3 feet. Test ground at blue wire and db gauge all checks out.