I was able to get the driver side one from there just they don’t have a passenger side for my car, I was looking at a 3g axel to see if it’d fit and they’re the same spline count for inner and outer just the length is longer by 2/10ths of an inch so I wasn’t sure it’d work or not
Would this cv work, I know spline counts are 27 annd 25 and matches and the compressed length call for 25-1/2 and this cv is 25-11/16. So just wondering if that 2/10ths of an inch longer would make it unusable?This was another I was looking at and just wasn’t sure how good they’d hold up, I...
Just curious what you all are using for your cv axel replacements, I just recently got a new driver side axel from o’reillys and just putting miles on that to see how it’ll hold but they don’t carry the passenger side so I’ve been looking elsewhere, looked on advanced and autozone and I don’t...
Alright so I just got my car back from engine builder and dyno last week and everytime I start my car and it’s in low rpms I can hear this clacking noise, I’m not 100% sure if I’m just tripping out and this is normal or what but I just wanna know what you all think. I’ll add the video.
So I went ahead and got a second ptu to test and it did it again so that leads me to believe it’s one of the coils just bc I just recently got my ecu with dsmlink so the ecu is fresh but how could I tell which coil is the culprit?
Some late nights being super tired made me cut the wrong wire at the ecu… lol went back to check my wiring and seen what I did… connected it all to the correct wire and boom it all started working😂
So I’ve been trying to get to the bottom of this issue and would like some opinions on it as well.So I took my car home from our shop about a month and a half ago and on the way home it got a bad misfire sounding like it was only firing on two cylinders, I thought it’s the crappy iridium...
Every time I set my narrowband simulation to on it just makes my car stumble and undriveable so I’ve just had it selected as undefined in the ecu input tab but when it is on it’s set to switch at 2.49v and my bottom options are set for a delay of 15secs and 0+ - and 0v and I now have it wired in...