New never used JMF drag SMIM with short runners made for 2G head. TB flange is Mustang 5.0, I.M was only bolted on engine. Never ran it.$450 plus $40 for shipping.(916) 715-634fiveThank you.
New never used JMF drag SMIM with short runners made for 2G head. TB flange is Mustang 5.0, I.M was only bolted on engine. Never ran it.$450 plus $40 for shipping.(916) 715-634fiveThank you.
Hey Josh I tried to go to meets and what not but your right it's been a long time since the last one I went to. I have not seen anybody post one.Maybe they'll pick up again with summer around the corner?
Make sure air is not going back in the system through the slave cylinder and that it is not leaking through there. Did you replace with OEM unit? Could be a possibility that it was a bad part.
Hello guys,Money is tight right now and I cannot afford a 2nd tune. I installed new downpipe and HKS 264/272 cams since my last tune.I am trying to tune for WOT but something weird is happening. It appears that at 5500ish RPM my afratioest goes to 14.7!!I was looking at the log and was...
When I did my hood I ended using 4 cans of matte black. Its best to remove hood and paint at a vertical angle. If you try to do it while the hood is on the car once the can is about halfway empty it will begin to splatter due to the can not absorbing enough dip. Also, make sure your coats over...
yes I believe it's a m8x1.25 rod about 7in weld some nuts at one end and grind the other end until you get rid of the threads. it should look like a smooth circle almost 2-3 inches from bottom.
i ran into the same problem but decided to not run coolant lines instead. When I though about it though, I believe you can splice the feed line into 2 using a "y"...