I went to autozone today for my check engine light. I found out the code is po170. What would cause this code. The car seems to run fine and I cannot hear any leaks at all. The car gets bad gas mileage (17 mpg average). I have replaced the EGR valve and now The car sometimes has a high idle when...
The autozone thing, I know I was a little embarssed to go there and have them run the codes ROFL I wasnt going to buy one there I just wanted to figure out an idea of what it could be. I put an egr on from a parts car at my work. I will get the code number and come back here.
Nope it doesnt have a blown head gasket. It isnt going thorough oil or antifreeze. It doesnt leak a drop of anything at all. It doesnt smoke or really do anything. I havent had to add a single drop of oil from its last oil change (about 2800 miles ago) and no antifreeze since the motor was put...
actually the head is a full reman. the whole engine has about 2000 miles on it and was installed by a veterian mitsu mechanic. I was wondering if this would cause my mpg to be low. I am only getting 17 mpg with my car. It runs good but just eats gas.
Well im gonna confess I took it to Autozone and they scanned it. They said I needed a new one. I had one laying around from a car that came into my work and I replaced it. The car seemed to run better but after a while the check engine light came on. I really dont know what the code was is there...
My 1996 GSX that is 100% bone stock is going throught EGR valves. My orignal one threw a code up and when I removed it the bottom port was 100% clean with some liquid on it. The top port has some carbon around in the port but nothing too bad. I replaced it with another one and my car threw up...
I have a 1996 GSX that is 100% stock with no mods at all. I just replaced the engine in the car and finished it up. Well now I have been driving the car for a couple of weeks now and put about 500 to 600 miles in the car and now the transmission is acting up. This only happens every once in a...
These are all to my 1996 GSX and I am getting frustrated on there they go...Ok the first one is long and goes into the fire wall on the passenger side.
<a href="http://s133.photobucket.com/albums/q70/munson4406cuda/?action=view¤t=Picture195.jpg" target="_blank"><img...
Hello all. I know this is not a DSM , but I really feel the need to post this. Nick Suckow had just gotten his charger stolen. the sad thing is, was that this car was done at John Balow's muscle car restorations for Nick Suckow who happens to be paralyzed from the neck down. it has a blown hemi...
Cool I was planning on doing the balance shaft delete. I was thinking of having the oil holes welded and smoothed out with the delete bearing in place. I bought a new timing belt, belt tensior, and timing belt idler from the stealership. Thank you for your advice i was wondering about those...