Check your crankshaft for end play. Jack the car up, remove driver's side wheel, grab ahold of the harmonic balancer and push it in and out.

I believe you can block bids and payments from anyone outside of the U.S. in both your ebay settings and Paypal.

Maybe it is out of view in the picture but you should put a circuit breaker on that power wire as close to the battery as possible (within 18"). The current rating should be about the same or a little higher than the alternator fuse.

Crank play is at most .035 inches or .899 mm measured at the crank pulley. Crank was pushed all the way in (toward engine) for the first measurement, second measurement was taken with clutch all the way to the floor. Probably closer to .02 inches but I took an average of the inner and outer...

Your assumption is correct about pushing the clutch pedal in. The GVR4s do use a 6 bolt engine and a CAS but that doesn't necessarily rule out a bad thrust bearing. The function of the clutch pedal being pushed in seems to put enough load on the engine to cause a substantial rpm drop. I'm...

Well I'm still trying to figure out my idle issues. I just finished installing a 160A Saturn alternator which did nothing to fix my idle/stalling issues. I currently have the common problem of stalling when come to a stop with the clutch pushed in or anytime the revs drop from 2k-3k or above...

Any chance of a small run of kits/subframes? I have an FD with a nice big hole where the engine should be.-Tim

Was this in OC? I saw it on craigslist and it looked really clean.

Metal Works, C.N.C. Machining and Engineering 1353 E. Borchard Ave. Santa Ana, CA 92705 Phone: 714-547-4429I've never used them but I went in to get a quote on brackets for my manual seat belt conversion and they seem to have decent prices. They also have a water jet machine which would...

Uhh.... keep it registered in Wisconsin. If you don't attract much attention, I'm sure you will never be questioned about it.

In the last two days, I have blown two ignition fuses in the exact same manner. Both occurred approximately 5-10 seconds after starting the car while closing my glove box. Both times the car shut off as a result of the glove box being closed and I am wondering where I should start looking for...

Luke is somewhat of a tool himself.http://www.rx7club.com/showthread.php?t=516235

I am currently swapping an LS1 into my CYM 1993 R1 FD and if you opened your eyes to the benefits, you'd realize why so many people are parting out their engines on RX7Club.com. I'm building it for 90% track use and the net cost to get it running is going to end up being around $5k including...

Well a transfer case can be removed easily and that is priced anywhere between $1000 and $1800 depending on the dealer.

Yeah, I kept the stock stereo in the Galant because it has the "Line In" port. Just use and MP3 player/CD player. No one is gonna steal the stock stereo from a 14 year old car and I carry my MP3 player with me.