Once traffic reaches "resignation" I will do the test.

I have a twin scroll set up with 20lb springs in 2 tial wastegates that are recirculating back into the exhaust controlled by a Hallman mbc. But I am building 30+ psi with the mbc back all the way out. Mbc was cleaned and checked, wastegates are authentic and new. Wastegates lines are ran...

Car fired right up this morning, must of been the wet coil pack as suggested. The pack is on a jmf bracket so I can see how water got to it. Thanks.

I went through a touchless carwash, and while pulling out of the wash bay my car died. The car turns over normally and will even backfire and sputter if the gas pedal is to the floor. I am assuming it is something stupid; probably related to the fuse box relocated under the passenger fender...

I reinstalled it, thanks.

Is the 1g throttle stop nessesary while running a 1g tb in a 2g car?

It's not the glove box light, I loosened it to show the glove box light.Never mind it is,

Installing a dash that I did not remove, and I can't figure out where this single green/red stripped wire goes. 99 2g.

From the inside, two bolts. Take the center console out and the driver side console side plastic. Should be able to pull it through from under the hood once it's loose.

Pick up the phone book and start calling or use google. 20-40 dollars would be a fair rate if I had to guess. Good luck.

02 sensor is snug and a 1/4 turn, I don't care if someone flames me for not using factory numbers on this.

I have extracted half a dozen of the broken turbo bolts/studs by hand, and by far the easiest method is to use a bridgeport. Whether it is finding a machine shop locally or knowing someone it has always been the eastiest way. I even broke a hardened bit while in the middle of extracting it by...

I needed a steel bov flange, but could only find aluminum so I had one made during lunch. Maybe this will help someone.

I have a 6 bolt bottom end, so finding a n/a pipe is doable, but I'm not taking it back off, I'll figure something out. The very worse case, hose and bolt with clamp.