OK, took it to a specialist, this is what they found:COURTESY CHECK CHECK ENGINE (CUST. THINKS THEY MAY NEED NEW ENGINE) -- Performed compression test and found 140psi on all 4 cylinders. We found spark plugs were fuel fouled and battery was dead. We recharged the battery enough for testing...
I apologize. I should have been more detailed and thorough. Ok:The car was located at International Car Center near Chicago. I live in Baltimore, MD. Did not want to travel up there and drive it back due to COVID. So I bought the car, and had it shipped here. Attached will be list of...
I have only basic experience, meaning I can do basic maintenance, fluid changes/flushes, filter changes, brakes and rotors, spark plugs, valve cover gaskets, etc. One of the reasons for buying this project car is to learn and do everything myself, once I get the car to spec, and good drivable...
Just got back from deale. 98K miles on motor. HE said they did not probably build short block properly, oil in cylinder one, that is why it wont start. He cleaned out spark plugs, etc, said to start it, crank it, and when it doesnt start, crank again immediately and it will start. I did...
Thank you all. My car ran just fine and then wouldnt start (would crank though). The used car dealer I bought from stated they rebuilt short block. Mitsu dealer is saying engine needs to be rebuilt, no compression or loss of in cylinder 1. I am not sure if I believe that cause car drove just...
Thank you! So Pauleyman recommended the AS series TZ/B, but I cant find that on Southbend's website. I did find a stage 2 daily there : https://www.southbendclutch.com/clutches/K05048-HD-O-4125/
Which one would be better, for daily and that could handle up to 300 HP? Thanks!
No, I am going over there shortly to talk about it. The service advisor mentioned for all the concerns found, they will use aftermarket parts, as OEM parts are not really available. So if I am going to drop 3-4K to get the car up to spec, I am sure they will put in a clutch and flywheel for...
Thank you! After this, i will definately perform thorough research. The South Bend AS Series TZ/B you have recommended, how much power it can it hold (hp) and where do you recommend I purchase it from? For the flywheel, is there somewhere I can just purchase, or where should I get it machined...
Thank you! This is just my project (toy) car. I want to upgrade it, at least 300HP, max I will ever take it is 400HP, do some suspension mods, but it will be a car I drive on the street, no tracking, ok maybe one time only as I have never tracked just to experience. I will drive it around...
Hello,
I am new to DSM and just purchased a 93 Talon TSi AWD. Needs some work, and rear main seal is leaking, so while dealer replaces the seal, I might as well have them put in a better clutch. I plan to take it stage 1 upgrade 250-300HP and possibly stage 3 up to 400HP. What is the best...
Greetings everyone!
Excited to be here and have the car. It is a black with beige leather, only one owner with 98K miles. Was curious since Eagle is no more, if wanting to take car to dealer, should it go to Chrysler or Mitsu? I want to have a good look over to make sure everything is good...