I'm looking for link now. Almost got one for 500 with eprom ECU, barely missed it. Anyways, I recently got an evo maf with filter (and wire to 1g plug). I replaced my 1g maf. I zeroed out my safc and I had to take it to +50 to attempt to get it to 100 (have logger no wideband yet, getting when I...
The 1g Control arm brackets are discontinued. I need the bushings replaced. I was told to get some delrin and have a machine shop make them. Tried calling around and it seems they cannot do it. Does anyone know if there is another bushing I can use to put in the bracket or can/has anyone made...
Get a spray bottle with liquid soap and spray around the couplers, fmic, bov, and throttle body. Check around the injectors and turbo as well!
Good Luck!!Sent from my PG86100 using Tapatalk
I have seen a few folks hanging at the SAM's off of Academy. Have seen about 15 - 20 vehicles. Not sure if it is vehicle specific. Check it out.My 1G has been sitting for almost a year. Haven't had much time due to Army and my family. Started recently. Replacing front suspension, removing A/C...
Thank you for the replies. I just wanted see if the problem progressed or diminished. In this case 3 out of 3 said it has diminished.I see there are like 5 or 6 different brands and a price range goes with them of $50-$190. Any recommendations on brand and why?
I found a thread on SS Brake lines, it was in 2007. I just want to see if the SS lines are still failing due to dirt getting through? Have the lines been improved since then? I was looking at goodridge, but saw they failed the most from what I could get. So Now it is between Techna-fit and...
Tried that but it did not work :( I may try to put a little more in, that stuff is THICK!!Thanks for the other advice everyone, guess I will buy the reman one then, it will save me about 50 and I wont have to take it apart!!! :rocks:
I currently have the Koyo Steering Rack and it is leaking pretty bad. I have searched aimlessly for a decent replacement. All I can find is the A1Cardone one for 220. In order to completely rebuild the Koyo it will cost 295, including seals and inner and outer tie rods. I know this part is not...
You can spray soapy water on the TB to check for leaks. You can hear if the seals are leaking in the TB. The FIAV is another reason you could be getting surge. I blocked mine off and that is what fixed my surge. Your IPS can also cause surge too.Try this if those dont work: Terry's Talon...
I have had a similar problem, but with a little different circumstances. My resolutions, first my head to manifold gasket was not fully tighten. The bolts came loose due to the heat (no lock washers). Another problem might be the wastegate. I have a MBC, and I could not get over 10 psi. I...
25S here. Will be 3 years on the 26th. Here at Peterson AFB with SMDC/ARSTRAT, looking to reclass to 68P! Good luck with your projects and nice to serve with everyone one of yall! :thumb:
I am posting this here because I have looked for the answer and cannot find it. Is the rear diff (4 bolt) rear seals part number MD707184? This is what the dealer gave me, I looked it up on a few Mitsu sites and it says it is for the front axels. Any help would be appreciative, dealer is...
It should not. I have done this a few times recently, is your throttle plate open for some reason, it should be closed unless the position sensor is opened to much for some reason? Take a multimeter and measure resistance, once it barely makes continuity, that should be the adjustment. The value...