Checked everything front and rear?
You said you replaced everything but haven’t checked the balljoints which come in control arms.
We’re going to need some pics front and rear and possibly a video doing a pull safely.
It could be torque steer but
Have you raised it and checked side/side and up/down play by moving the wheel?
Have you visually inspected the suspension? Balljoints, bushings, control arms.
Rotated tires?
We need a base to start and pics help.
It’s wired incorrectly but I don’t have a diagram that might be right until tomorrow.
You have every red wire going to that plug and that doesn’t seem right.
There’s other wires going to below the headlight itself.
I’m still in the wiring trying to figure out what I do and don’t need to thin the harness. I’m probably going to run the harness from wheel well to wheel well differently to make room for other things.
I also just started cutting to make room...
Took it for the first drive yesterday. Although only a few miles everything went well. No crazy noises and no puddles under it LOL. Today I decided to wash it up and give it a quick detail.
I’m still figuring out the wiring. Speed density labeled and ready but I’m in between map sensors and don’t know if the resistance in the RIFE sensor would kill the DSMlink but I have a Omni 4 bar.
Second thought was the radiator support and...
It’s either not the issue
Is the issue but it’s not seen
Or a completely different issue that came up
You can do a resistance check from the other end of the harness to the connector to make sure it’s good.
Pin 8 has a repair
The black and white...
If you have those two black and white wires mixed up it’s probably shorted anyways but you could try it.
What’s that black wire going to the positive cable end?
I'm going to show you how to install a fuel pressure sensor and log it with ECMLink.First off, I was going to purchase a name brand fuel pressure sensor but after talking to a few people, I just went with an el-cheapo off eBay.
Just make sure...