I have for sale, a set of slightly used forged Eagle H-beam rods with ARP 2000 bolts (CRS5900MB3D) from my 97 Eclipse GSX. These rods have the same length and bore size as the stock 93+ 4G63t but is rated for up to 750Hp while remaining lighter than stock. They have been wonderful for my 68HTA...
Is that the only oil port into the head or does the turbo oil feed off the head come from a different port? From what I read it it two different oil passages into the head but it wasn't very clear.
I was doing a head gasket job on my 2g 7bolt motor and while I was cleaning the block I stuffed blue shop towels down every hole on the block so I didn't contaminate the inside of my block from scraping the old gasket off. My problem is one of the little pieces of towel would not come out and I...
I tried the pliers but it's caught up on the threads. A buddy said I should try to use JB weld and stick a new bold on the end but if that does'nt work how do I go about replacing the tensior while its still semi tight.
My engine is in the car and I after everything was back together after a head gasket job I stared loosening the long bolt to take slack out of the belt and it snapped about a half inch away from the threads. I have no idea what im going to do, will I need to pull the engine out and replace the...
I have an evo III intake manifold but I cannot find a 1g throttle body for it so I was wondering if the manifold can be bored out to 70mm with no problems, then I can get an s90.
Venom hi flow hi performance fuel rail. Pulled this off my 1997 eclipse gsx. The top is compatible with the stock fuel pressure regulator or you can block it off and use the sides. $130Text (605)789-1046
Pulled this billet aluminum blow off valve off my 97 eclipse gsx, both ports are 30mm and fit into the stock intercooler piping and intake. $60Text me (605)789-1046
Thanks for the replies! just ordered some HKS 272s. Also I have the v2 68hta and I am playing around with a super short route water to air intercooler setup so I can run some 10.5:1 pistons. Juan Mascorro did 501hp/444tq on high compression and e85 on a drag setup.
I am building my gsx to be a street car that can rip up the auto X. I have a 68hta on e85 making around 400hp and my goal is 500whp on this turbo with high compression. So what cams would be the best for my goals? I do not want to loose much low end power, but more power up top would help me...
This was one of my projects for a woods class and I decided why not post it up. All you need are some clamps, band saw, and sandpaper. It does not have wheels and it's just a cut out side view of the car but it makes for a nice toy for the kids.
I made a quick informative video on how to choose the proper size intercooler piping to achieve maximum efficiency and spool without being a restriction, This information is from gstryyder and I do not claim credit, I just feel everyone should know this information. Also please read the thread...