Their current policy is that they must spray for you. Just be aware, not necessarily a bad thing, but it adds cost. Just give them a call?gopatrickfl.com
The pistons didnt exceed deck height from what I could tell, but I know the head was decked aggressively, thats why I am asking what to do to make up the difference in head height. I am assuming a thicker head gasket is safe?edit: lol pretty sure I put the trigger plate on reversed. That...
I am using the 2g oil pump so I can keep the 2g crank pos sensor thus I am using the trigger plate for timing just like a 2g. It should time correctly.
I just finished replacing the headgasket on a motor I bought from the junkyard. It appears the motor has been milled down aggressively as even the depth checkers on the head have some machine marks on them. I did the timing, correctly mind you, and the valves seem to touch the pistons when...
Right and you have to do that anyways with just using a 2g oil pump on a 6 bolt anyways so why not just use a 2g oil pump? Its far cheaper since you probably already have one lying around.I just did the rre og way . It only ran around 50 bucks after it was said and done. I would way...
I am having this exact same problem.I have swapped in my 95 ecu with dsmlink and the problem goes away, ofcourse. Any 97-99 ECU I use will missfire once in steady condition above 2300 rpms regardless of gear.Its seems as if, that the ecu sees the misfire and shuts off spark and fuel to...
The demographic a car just happens to be most associated with, has no bearing on its actual capabilities. If you hate the demographic DSMs are associated with and hold the car responsible THEN GET THE #### OUT OF THE SCENE. Don't come in here whining about "whiners" who are trying to stand up...
Dont listen to people that dont uderstand how to build a 7 bolt without having it walk.There is no excuse for a motor to walk. If a motor walks it walks because THE ASSEMBLER didnt check everything. THere are plenty of theories, and they can all be resolved.Some believe the oil...