Figured it was worth a shot. Are you describing inverted flare fittings?2G Turbo feed line fittingsI don’t find any matching that description, exactly. But eBay does have this DIY option where you drill the 0.075” hole through.
I finally figured it out! My passenger seat belt works now :D Apparently I had a bad sensor inside the door, it's located next to the door lock mechanism, it tells the seat belt when the door is completely shut. It was a real pain in the a**...
Finally got around to swapping in a 6-bolt and and the new trans over the weekend. Need to reassemble the front suspension and get the rest of the drivetrain connected before I can test her out.
Alright, last update before this thread is caught up with my real-time progress.After the front of the block was assembled, It was time to do the rear main seal. And - as always - something had to go wrong. This is what the oil pan bolt hole...
Speaking of PC done right, I picked up the latest work from Rich - This is so coolLater you will see more of this billet plug cover - It is crazy good. The top surface of the grill is polished aluminum with clear on top, like the letters on...
First thing is first - check the level of the brake fluid in the master cylinder. The light being on will not cause the vehicle to operate in limp mode.Good thread for reference: https://www.dsmtuners.com/threads/ebrake-light-stays-on.36497/
It appears another ‘90 non-turbo transmission should be a direct swap. I cross-referenced part numbers for clutch, pressure plate, throw out bearing, fork, slave cylinder, and both axles against a December 1989 non-turbo VIN. They all match...
Agreed. For that VIN, the transmission model pops up in CAPS as KM206-0-DJNS, part number MD995455. Very early transmission - VIN specifies production period of the vehicle to be the first third of March, 1989.Why the KA instead of KM20, I...
To update this, only proper solution is to run a lower 6 bolt timing cover with the top cut down with a 7 bolt mid cover to work with a 2g mount.Apparently rix racing is also coming out with covers for a 6 bolt in a 2g as well, not sure if he...
OOoo nice. I've got a roll of ASA I haven't opened to play with yet. Also some PC that I'm scared to even try. 🙃 Great idea on the foam from an insulation and sealing standpoint. I should have realized that.I'm on Inventor and it has an...
1G Eagle Talon, Plymouth Laser, and USDM GVR4 Spark plug cover. Again, not 100% correct. Use for reference only or assume any and all associated risks. /covermyasslegalese