Ace Hardware keeps small plugs in their bins, measure the hole and see what you can find.

I wonder how thick the material is

I had a JB 6262, lasted 2000 miles with good VR1 20w50 in the summer time. Made good power at 39 psi however.The ball bearing units are a lot better quality.

I stand correctedThat thing is rough, I'd have a hard time paying over $50 got that mess

Fake, TiAL was never raised on the actuator body. Here are some comparisons TiAL Sport.com

No problem, glad you got it figured out!

If you have a thread chaser you should use it first, if not take two nuts put on the manifold side of the stud tighten them against each other and using care that the stud is straight use a ratchet to twist the stud in using the outer nut.If the whole hole is stripped out you will need a...

Here is proof that you can put a 4G63 engine in a RS or GS.

You could perform a leak down or a compression test to see if there is a large variance between the cylinders.

Yes sir, it's the control box for an Apexi Turbo timer.

What kind of air flow numbers were you seeing?

Ecmlink V3 has Direct access files to over come the ISC issues. I am running a 2G ECU with V3 and SD on my brothers Evo.It is missing the Idle switch pin you can also use ECMlink V3 to simulate the idle switch.

Look up Adam Porto on facebook, he was the guy making all the custom mounts for the front and rear subframe, rear differential and motor mounts.

Andrew does great work, as soon as I saw Tims car I had to run over and check out this unit, the oil cap is even baller!

No looks like the drivers side strut tower is rusty and zip ties to hold the bumper on, total hack job...