Cherry
Proven Member
- 277
- 60
- Jun 16, 2019
-
Hull,
Georgia
I have a 1g 7 bolt 4g63 and the timing belt is riding the inside of the cam gears (overlapping the edge a little) and did research to find the cause is most likely the tensioner arm and the front cover gasket could be causing an issue creating a wedge.
All I want to know, and ive looked, is if the 1g 7 bolt timing belt tensioner arm is the same as the 2g timing belt tensioner arm.
I had a timing belt shred in 3 pieces only going about 40 in a school zone, replaced the trigger plate which I seen was bent either because of the timing belt shredding or just got worse (was about 1/8inch into the timing belt) so I want to get the timing belt sat properly and just want to know if they are interchangeable. I tried looking on not only the forums but elsewhere on the internet and just cant find an answer.
I just dont want to waste the money on something that isnt going to work.
All I want to know, and ive looked, is if the 1g 7 bolt timing belt tensioner arm is the same as the 2g timing belt tensioner arm.
I had a timing belt shred in 3 pieces only going about 40 in a school zone, replaced the trigger plate which I seen was bent either because of the timing belt shredding or just got worse (was about 1/8inch into the timing belt) so I want to get the timing belt sat properly and just want to know if they are interchangeable. I tried looking on not only the forums but elsewhere on the internet and just cant find an answer.
I just dont want to waste the money on something that isnt going to work.