SyntheticD
Probationary Member
- 8
- 0
- Jul 31, 2020
-
Rupert,
Idaho
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
You'd have to re-bush the bottom of the strut, but you could use an AWD strut for the rear, raising the height by about 3 inches.
Ok to not use bushing on bottom of Strut?
I have looked into pretty pricey to pull the struts and then take them to the machine shop and have them make 30mm spacers then get new bolts for the strut.Have you considered a spacer plate between the shock and shock tower?
Well I'll figure out some way to lift it for now I have the trans out replacing clutch rear main seal oil pan and seal and make a skid plate for it.
I’m also building a 1g for the Gambler. Are you going to be at SIG this year? Also any update on this suspension lift? It’s difficult to find info on this, yet it has been done plenty of times.
My bad I should have clarified. SIG is the Southern Indiana Gambler. It’s from Oct. 30-Nov.1 this year. That may be just what I have to do is say screw it and go hahaNot sure what SIG is. but no luck with the lift just been sending it . I had to redo the clutch cause it went out I have added custom bumpers and a tow bar and winch.
Just strip it down a s run it . I been doing Idaho gamblers. 4 so far.