Ryan1gGst
Probationary Member
- 19
- 1
- May 1, 2016
-
Kalamazoo,
Michigan
As the title states. I know this topic has been beaten to death but I can not find any other fixes. I'm tired of my oil pan leaking. Motor built by a reputable shop here. Wiseco pistons (stock bore), Manley Hbeam rods, acl rod and main bearings, kiggly beehive valve springs and retainers, crane 264 cams. New acl oil pump. I have had my ffofh ported and it didnt help. Cold start seeing 130psi. Warm idle around 30-35. Giving any gas it shoots up to 100. At 55mph, full operating temp, around 90psi. Under any boost it will peg my gauge at 150 psi. Sensor is on the ofh. Tuned at 21lbs on a small 16g. Running a catch can with -10 fittings on the side of the cover. New oem pcv in working order. After the first two times the pan was leaking I bought a new oil pan. Cleaned all the surfaces and reinstalled with permatex (the right stuff). Failed, took it all apart, re did the gasket. 1/4 bead and going around the outside of bolt holes. Torqued to spec. Let it cure over night. Started up, idled for 20min, no leaks, drove it without building boost for 5min, parked it, and leaking from under timing side again. Took the cover off, pulleys back on a confirmed its seeping out of the pan and no where else.
Any other suggestions would be much appreciated. Tired of having a broken project.
Thanks
Any other suggestions would be much appreciated. Tired of having a broken project.
Thanks