Th3ory
Proven Member
- 219
- 29
- Aug 6, 2015
-
Centralia,
Washington
This is a simple project compaired to whats going on out there. But I figured I would share anyways.
I started this today, and still need to clean up where I cut out the hole for the intake pipe to go through to the fender. I will use a drimel and grind all of the hole smooth, then put a seal around it. I also plan on getting all silicon hose couplers in black, intake and intercooler. Some are blue and some are black at the moment.
I had a short ram SD intake already on the car, but figured I was pulling in a lot of hot engine air.
All the piping is 3.5 inch, off of an FP Green.
I started this today, and still need to clean up where I cut out the hole for the intake pipe to go through to the fender. I will use a drimel and grind all of the hole smooth, then put a seal around it. I also plan on getting all silicon hose couplers in black, intake and intercooler. Some are blue and some are black at the moment.
I had a short ram SD intake already on the car, but figured I was pulling in a lot of hot engine air.
All the piping is 3.5 inch, off of an FP Green.