talont3t4
20+ Year Contributor
- 416
- 0
- Feb 9, 2003
-
Edmonton,
AB_Canada
Here is a fixture we did up to allow us to drill out bearing for use with aluminum rods. For anyone that doesn't know you need to run a dowel in aluminum rods to keep the bearings from spinning.
Here is a stock 6 bolt rod that was machined flat
Then machined the rod out and pressed in a hardened insert for the drill to ride in
Here is the final version done and tested
Here is a stock 6 bolt rod that was machined flat
You must be logged in to view this image or video.
Then machined the rod out and pressed in a hardened insert for the drill to ride in
You must be logged in to view this image or video.
You must be logged in to view this image or video.
Here is the final version done and tested
You must be logged in to view this image or video.