compression
15+ Year Contributor
- 1,433
- 11
- Dec 9, 2004
-
vero beach,
Florida
i got the car running with a stock 1g mafs, a friend let me borrow it and needed it back. so now all i have is the map for sd, i am also running an s90 throttle body and im not sure if i did it wrong , but im not getting any tps signal ( ecmlink shows 0% ) well, anyways i was realllly hoping somebody could share their table with me to get this car running , i know every car is different and all but i can fine tune it myself. or maybe i am doing something else wrong i dont know,
i can get the car to start and barely idle but as soon as i hit the gas it dies. ive tried adjusting the fuel and air sliders and the same thing occurs. i have the sensor set up as speed density i have airflow smoothing turned off, and i set the signal wire to baro i have a plug and play harness from ecmlink, i assume thats the wire they use? either way the log shows it reading airflow. i dont get it
edit : didnt set pin assignments, had coolant temps locked for some reason, had the wrong map sensor check ( gm 3 bar ). starts and rev's no problem. ( for the time being )
i can get the car to start and barely idle but as soon as i hit the gas it dies. ive tried adjusting the fuel and air sliders and the same thing occurs. i have the sensor set up as speed density i have airflow smoothing turned off, and i set the signal wire to baro i have a plug and play harness from ecmlink, i assume thats the wire they use? either way the log shows it reading airflow. i dont get it
edit : didnt set pin assignments, had coolant temps locked for some reason, had the wrong map sensor check ( gm 3 bar ). starts and rev's no problem. ( for the time being )
Last edited by a moderator: