Speed6Mark
Probationary Member
- 4
- 0
- Mar 7, 2011
-
Orlando,
Florida
Since i am a "newb" and can't ask a question in the appropriate sub-forum (weird rule IMO) i have a PTE 6262 question i have not been able to find in this forum and among the internets.
I have a the JM Fab bottom mount exhaust manifold, and it is flanged at the turbo for the Tial V-band flanges.
I want to use a PTE ball bearing 6262, but i am unsure of a few things.
1.) is the Tial flange the same size as the PTE V-band in/out housing?
I am unable to find flange dimensions on the 6262 V-band housing.
2.) if it is not, will the tial housings fit on the 6262 CHRA?
Any help would be appreciated, as well as suggestions on using a .68 or .82 turbine A/R for my setup:
272/272 Kelford
Ferrea valvetrain
built motor
JMF intake and exhaust manifolds
Tial gate and BOV
Link V3
VRSF FMIC Kit
I have a the JM Fab bottom mount exhaust manifold, and it is flanged at the turbo for the Tial V-band flanges.
I want to use a PTE ball bearing 6262, but i am unsure of a few things.
1.) is the Tial flange the same size as the PTE V-band in/out housing?
I am unable to find flange dimensions on the 6262 V-band housing.
2.) if it is not, will the tial housings fit on the 6262 CHRA?
Any help would be appreciated, as well as suggestions on using a .68 or .82 turbine A/R for my setup:
272/272 Kelford
Ferrea valvetrain
built motor
JMF intake and exhaust manifolds
Tial gate and BOV
Link V3
VRSF FMIC Kit