The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support ExtremePSI
Please Support ExtremePSI

changing my set up

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

awdmonster1904

15+ Year Contributor
788
387
Aug 23, 2007
Chino, California
well is that time of the year again ive been ruining consistent 7.5 in the 1/8 mile
runing 11.7@121 and i would like to go faster

so I picked up a few goodies

Race JMF SMIM
FP GREEN

hopefully my current setup and the new mods will get me in to the high 10 sec range low 11
this will be on E85 30 psi maxing out the green any suggestions or advise ?
 
I suggest you get something better than those used street tires you attempted to get traction with last year. I'm looking forward to seeing what the setup can do with that FP Green Frank, you might end up needing more fuel pump.

:dsm:
 
I suggest you get something better than those used street tires you attempted to get traction with last year. I'm looking forward to seeing what the setup can do with that FP Green Frank, you might end up needing more fuel pump.

:dsm:

Yeah I was thinking of getting the jays racing fuel pump but I'll see if I maxed it out the 255
I have another set of tires I gotta give a try Out
 
Yeah I was thinking of getting the jays racing fuel pump but I'll see if I maxed it out the 255
I have another set of tires I gotta give a try Out

Yeah Frank, I can't wait to see how your car does with that FP Green. I wish that Deatsch Werks pump would have been out before I bought my O44.. oh well. :D
 
Dyno sheet coming soon
Sam fro RRE. Made it happend on the dyno 430 hp 400 lbs tq E85 30 psi
On a stock six bolt. 150-150-120-150
My IDC 90%. Later that day when I was at the drag strip the cylinder that had 120 took a dump busted a ring gland I still ran 11.9 but the compression dropped to 30 the rest are on 150
All well 5 years of ultimate abuse and boost the good old six bolt retired

Now I'm in the works of a 9 to 1 motor with eagle rods 20 over JE pistons
Let's see what happens
 
Last edited by a moderator:
Good news and bad news in the same post. good numbers but dang that sucks about the block
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top